Routine maintenance, Replacing the lamp – PRG VL6C+ User Manual
Page 52
44
VL6C+ ™ SPOT LUMINAIRE USER MANUAL
ROUTINE MAINTENANCE
Replacing the Lamp
Parts:
71.2528.0700.0
LAMP, MSR 700W
Tools:
Screwdriver, #2 Phillips
Screwdriver, slotted
WARNING:
Remove power from luminaire before performing any maintenance procedures.
CAUTION:
"Proper Lamp Servicing and Operation"
on page 43 before handling the lamp.
To replace lamp:
Step
1. At APS6 module, remove power from lamp and allow lamp to cool for at least 5 minutes.
Step
2. Remove power from luminaire.
Step
3. At backcap, loosen captive knob and slide backcap out of head assembly (it will remain attached by tether).
Step
4. Remove lamp by pulling straight out of socket.
Step
5. Noting polarity of lamp to socket, install new lamp by pressing firmly into socket, making sure it is fully
seated.
Step
6. Align guide rods in guide holes and slide backcap into head assembly.
Step
7. Ensure that backcap is fully seated in rear chassis and re-tighten captive knob.
Step
8. Align lamp. (Refer to next procedure.)
Figure 4-1: Lamp Replacement
Head Assembly
Guide Rods
Lamp
Backcap
CAUTION:
Do not touch lamp or
reflector with bare fingers.
CAUTION:
Allow lamp to cool
before servicing.
Captive
Knob