PRG Mbox Designer User Manual v3.6.1 - Manual (Page 149)

MBOX ® MEDIA SERVER USER MANUAL 141
Timecode Window
To toggle the Timecode window on and off, press [  T] on the keyboard.
+ Source – choose the appropriate source for timecode: Generator, Audio In Left, Audio In Right, or MTC (MIDI
timecode).
+ Output – Local (internal routing only), or an active Ethernet port (for sending timecode over the network to MBOX
servers).
+ Auto-Start – enabling this will cause timecode be active as soon as the Remote application launches. Depending
on the source setting, the application will immediately begin generating or listening for external timecode.
+ Start Time value – specifies where the internal generator will start.
+ End Time value – specifies where the internal generator will loop back to the start time.
+ Start – starts generating code from Start Time value if generator is selected, or will start listening for external code
if not.
+ Stop – stops generating internal code or listening for external code.
+ Resume – resumes generating internal timecode from current position.
Note: The Timecode window does not have to be visible to function. If timecode is being received, it will be shown at
the top-right of the Remote main window.
Note About Thumbnails
The Remote application had a tab that allowed you to see the stored content, effect, and transition thumbnails on the
selected server, however, this functionality has been removed. Instead, you can use any browser to view the same
information. Just type the computer’s IP address into the navigation field of the browser:
http:// IP Address of computer
For example:
http://192.168.0.123