PRG Mbox Designer User Manual v3.6.1 - Manual (Page 33)

MBOX ® MEDIA SERVER USER MANUAL 25
SETUP
Basic Setup and Connections
To interconnect the case components:
Step 1. Remove front and back covers from case (Figure 2-4).
Step 2. Remove keyboard and trackball from case.
Step 3. At rear of case, verify that Monitor (2), USB (3), Ethernet (2), Video In (2) and Power cables are connected to
computer.
Figure 2-4: Removing Covers and Components
Step 4. At front of Dual I/O module, connect local monitor data cable to DVI connector labeled "Preview."
Step 5. Connect local monitor power cable to UPS or to local AC power service.
Step 6. Connect UPS power cable to local AC power service.
Step 7. Connect stage outputs and other MBOX EXTREME servers (if required) according to the following sections.
S ITE WIR ING
FAULT
OUTPU T: 120V 50/60 Hz SENSIB ILITY
INP UT
RE SET P USH TO
P ROTECTOR OVERLOAD
US B PORT
(COMPOSITE)
Y IN
BALANCED AUDIO OUT
ETHERNET LEFT RIGHT SMPTE IN MIDI IN MIDI OUT SDI IN R - Y IN B - Y IN
Remove covers 1 2 Remove components
Monitor, USB, and Ethernet Connections
Connect monitor
AC cable to UPS
To AC Power
Connect monitor
data cable to DVI
3 Verify rear connections 4 Connect monitor and power source
Preview
(permanently connected - do not alter)
To AC Power
Auxiliary Input
Connections
or local AC