CMS Products 674 - Manual (Page 21)

HotCup Operators’ Guide Initial Setup
November, 2007 15 6740001
III. CONNECTING EVERYTHING
1. Connect the Merchandiser to the Water Supply:
a. You will need the following:
•A coil of copper tubing with outside diameter of 3/8 inch (9.5 mm) or greater. The
appropriate plastic tubing may be substituted. The tubing must be long enough to reach
from the water source to your machine with enough left over to form a loop about 2 feet
(60 cm) in diameter. This will allow you to move the machine without straining the water
line.
•A 3/8 inch (9.5 mm) flare fitting.
b. Connect the merchandiser to your water supply.
2. Connect the Merchandiser to the Electrical Power Supply:
Power inside the merchandiser is controlled by the main power switch, located on the power panel.
a. Make sure the main power switch is OFF.
b. Connect the merchandiser’s power cord to your wall outlet.