CMS Products 674 - Manual (Page 37)

HotCup Operators’ Guide Initial Setup
November, 2007 31 6740001
3. Install Canisters.
a. Place the canister in position as shown.
b. Engage the pins on the motor shaft with the slots in the canister coupler.
c. Fit tabs on canister into the slots on the canister shelf.
d. To ensure canister is correctly engaged with the rear mounting bracket, gently push down on
the front edge of the canister lid.
626P0017
FILL
CANISTER FILL
CANISTER
CANISTER
SHELF CANISTER
SHELF
PINS ON MOTOR
SHAFT MUST ENGAGE
SLOTS IN CANISTER
COUPLER PINS ON MOTOR
SHAFT MUST ENGAGE
SLOTS IN CANISTER
COUPLER