CMS Products 674 - Manual (Page 48)

Monetary Setup HotCup Operators’ Guide
6740001 42 November, 2007
SELECT BILL VALIDATOR AND OPTIONS
a. Press , then press until one of the following is displayed:
NO DBV No bills will be accepted or there is no bill validator installed (you can
exit the function).
SER.1.2.5.10.20 The serial bill validator is selected and will accept $1, $2, $5, $10,
and $20 bills. Use BILL SELECTION METHOD below to change
the bills which will be accepted.
MDB.1.2.5.10.20
A standard MDB bill validator is selected. It will accept $1, $2, $5,
$10 and $20 bills. Use BILL SELECTION METHOD below to
change the bills which will be accepted.
BILL SELECTION METHOD:
The standard $1, $2, $5, $10 and $20 bills are enabled by pressing
the 1, 2, 5, 6, or 7 key(s), respectively, to display which bill(s) will be
accepted.
MDB. <*>
An MDB bill validator which accepts nonstandard bills or tokens is
connected and operating. Press to enter list of bills.
(See “Initial Setup of a Nonstandard Bill Validator” on page 43).
BILL LIST OPERATION:
Use and to scroll through the list of bills.
Use to turn the bill acceptance ON or OFF.
Use to move up to the top level screen.
1. 1.00 ON
1. = Bill validator channel 1, each bill has its own channel
1.00 = Bill value
ON = $1.00 bill will be accepted
1. 1.00 OFF OFF = $1.00 bill will not be accepted
TKN Token bills (same as coupon bills)