Whipper options, Hot drink setup hotcup operators’ guide – CMS Products 674 User Manual
Page 56
Hot Drink Setup
HotCup Operators’ Guide
6740001
50
November, 2007
WHIPPER OPTIONS
WHP. A XXX
Press
to view and change the whipper settings as follows:
ON-
The last 3 seconds of the drink is always whipped
ON+
The whole drink is always whipped
OFF
The drink is never whipped
opt
See below
•
If
J+
is selected (See “Set the Machine Type Configuration Code” on page 55):
OPT-
The last 3 seconds of the drink is whipped only when the J key is pressed
OPT+
The whole drink is whipped only when the J key is pressed
•
If
J-
is selected(See “Set the Machine Type Configuration Code” on page 55):
OPT-
The last 3 seconds of the drink is whipped unless the J key is pressed
OPT+
The whole drink is whipped unless the J key is pressed
DIFFERENCES:
Some selections will not show all of these items. The E selection will have some additional
selections:
WA.2 E
View and set the water throw time for the cappuccino second product (chocolate)
DR.2 E
View and set the chocolate throw time for cappuccino
PCT. E
To automatically compute new times for cappuccino, enter a percentage, then
press . This percentage represents the amount of chocolate product in
cappuccino, versus that in a normal chocolate drink. This time and the normal
coffee settings will compute the new cappuccino time.
(This is a handy way to move from one selection to another without going to the
SETUP
screen first.)
If you try to set up a selection that is not configured, the
SETUP
screen will remain in the
display.
OPTIONS:
i.
At any of the preceding displays, you can press
to test throw that item.
ii. At any of the preceding displays, you can press * or # (on the selection switch panel) to
step through a list of that item’s throw times for other selections where that item is active.
For example, pressing # at the
WAT. A
display will show the throw time for
WAT. B
. This
is a handy way to move from one selection to another without going to the
SETUP
screen
first.
NOTE
If you try to set up a selection that is not configured, the
SETUP
screen will remain in the display.
e. Continue.