SilentKnight 5600 - Manual (Page 73)

Programming
151450 6-11
6.6.5 Relay Programming Options
The two on-board relays of the control panel can be programmed for Auxiliary
Resettable and Auxiliary Door Holder applications. Relay 1 can be selected to
activate for General Supervisory. Relay 2 can be selected to activate for General
Alarm. See Figure 6-1.
Figure 6-1 Relay Programming Option
6.6.5.1 General System Relay Silence Option
This option defaults to silenceable. This option controls the silencing behavior for
Relay 1, Relay 2 and the general output relays at SLC addresses 141 through 148.
6.6.6 Dialer Phone Line Programming Options
The programming options below are available for each of the two phone lines.
6.6.6.1 Line Prefix
This option allows the insertion of digits, delays and special tone characters to be
dialed before the phone number stored in the account option is dialed. The default
setting is to not have any prefix.
6.6.6.2 Dial Tone Detection
The default configuration for this option is “Enabled”. If set to “Disabled”, the dialer will
not check for the presence of dial tone on the associated phone line prior to making a
call.