Solvline Eddy DKV2.1.0.3 - Manual (Page 115)

Chapter
9. Appendix
115
4) Turn on Eddy-DK/S4M-DK board.
5) If Eddy-DK/S4M-DK board is recognize on your PC, maybe a dialogue box will be
pop-up for installing new hardware. Choose the recommended mode install the
software automatically then click Next.
6) Click Continue Anyway to proceed with installation.
7) Complete the found task. Click Finish to successfully install the driver.
8) Pull up both of S6 Dip switch on Eddy DK v2.1 board (Eddy-S4M  S1 dip switch)
9.2.4 Preparing Firmware Files & Utilities
Prepare firmware files and flash writing utility programs as follows.
1) Copy usb_recovery_xxx.zip file to any directory (e.g. C:\SystemBase\USB_recovery)
from SDK\Windows\USB_recovery directory in Eddy DK CD. (Refer to the Eddy
official community site http://www.embeddedmodule.com)
2) Among files extracted copy isp-extram-at91sam9260.bin file to the below directory.
C:/Program Files/ATMEL Corporation/AT91-ISP v1.12/SAM-BA
v2.8/lib/AT91SAM9260-EK
3) Among files extracted copy below listed files to the firmware directory in DK source
code directory.