Solvline Eddy DKV2.1.0.3 - Manual (Page 24)

Chapter 2. Getting Started
24
Peripheral B : TIOA5 Timer Counter ch5 I/O Line A
12 PB18 J11_12 J2_19
Peripheral A : TD0 SSC Transmit Data
Peripheral B : TIOB4 Timer Counter ch4 I/O Line B
13 HDMB J11_13 J1_28 USB Device Port Data -
14 PB19 J11_14 J2_20
Peripheral A : RD0 SSC Receive Data
Peripheral B : TIOB5 Timer Counter ch5 I/O Line B
15 HDPB J11_15 J1_30 USB Device Port Data +
16 PB20 J11_16 J2_21
Peripheral A : RK0 SSC Receive Clock
Peripheral B : ISI_D0 Image Sensor Data 0
17 A16 J11_17 J3_3 External Address Bus
18 PB21 J11_18 J2_22
Peripheral A : RF0 SSC Receive Frame Sync
Peripheral B : ISI_D1 Image Sensor Data 1
19 A17 J11_19 J3_2
External Address Bus
20 A18 J11_20 J3_1
21-28 D[8:15]
J11_21
~J11_28
J3_28
~J3_21
External Data Bus 8-15
DK is directly connected with CPU and external connecter (J3) is connected by buffer.
PC13(NCS6 : Chip Select 6) should be enabled for working buffer, if it is reset, it work
as Pulled-up input.
29 TWD J11_29 J4_3 Two-wire Serial Data. This pin cannot be used for GPIO.
30 TWCK J11_30 J4_4 Two-wire Serial Data. This pin cannot be used for GPIO.
31 NANDOE J11_31 - NAND Flash Output Enable
32 A22 J11_32 J1_29
Address Bus
DK is directly connected with CPU and external connecter (J3) is connected by buffer.
33 NANDWE J11_33 - NAND Flash Write Enable
34 A21 J11_34 J1_30 Address Bus
35,36 NC Not Connect