Cuisinart SMARTPOWER DUET BFP-603 - Manual (Page 9)

9
FOOD PROCESSOR ASSEMBLY
Please note that the bowl with collar will fit on the base in eight
different positions. The handle can be in front or on either side, and
the feed tube in front, back, or on either side. Directions for use
reference a certain position for instructional purposes only.
CHOPPING BLADE ASSEMBLY
1. Hold work bowl collar in one hand and work bowl handle in the
other. Twist bowl clockwise onto collar.
2. Place collar with bowl onto motor base with handle facing front.
3. Place chopping blade over shaft in work bowl. Chopping blade
should slide easily to the bottom of the bowl. Lower blade will
almost touch bottom of bowl.
BE SURE TO HANDLE THE METAL BLADE WITH CARE,
AS IT IS RAZOR SHARP!
4. Put cover on work bowl, with feed tube at about 11 o’clock. Turn
the cover clockwise until it fits into position. Cover lock must
click into locked position prior to use. If you have trouble fitting
the cover on the work bowl, turn chopping blade hub slightly and
replace cover.
5. The food pusher fits in feed tube with the more rounded side
toward the outside of the bowl.
6. Plug your unit into a wall outlet.
7. To remove cover, unlock it by turning it counterclockwise, then
lift it straight up.
SLICING AND SHREDDING DISC ASSEMBLY
1. Hold collar in one hand and work bowl handle in the other.
Twist bowl clockwise onto collar.
2. Place collar with bowl onto motor base with handle facing front.
3. Place adapter stem onto the center shaft. Place the slicing/
shredding disc onto shaft with the desired cutting blade facing
up. To slice: Attach disc to stem with the raised edge of slicer
on top. To shred: Attach disc to stem with the raised shredding
slots on top. BE SURE TO HANDLE THE METAL DISC WITH
CARE, AS IT IS RAZOR SHARP.
4. The food pusher fits in feed tube with the more rounded side
toward the outside of the bowl.
5. Put cover on work bowl, with feed tube at about 11 o’clock. Turn
the cover clockwise until it fits into position. Cover lock must
click into locked position prior to use. If you have trouble fitting
the cover on the work bowl, turn chopping blade hub slightly and
replace cover.
6. Plug your unit into a household electrical outlet.
7. To remove cover, unlock it by turning it counterclockwise, then
lift it straight up.
OPERATION
Your SmartPower Duet ® Deluxe appliance uses the Low and High
speeds with the food processor attachment. When using the food
processor, always use High when slicing or shredding, and either
High or Low when chopping. You may also use the Pulse button set
on Low or High for pulse chopping.
CHOPPING BLADE FUNCTION
1. To use your food processor, make sure that the bowl is
assembled properly and the chopping blade and cover are
locked into place.
2. Add ingredients to the work bowl, either through the feed tube
or directly into the bowl.
3. Press the On/Off button.
The red LED light will illuminate
and flash. For continuous
operation, press the Low or
High button. Motor will start
if you have followed Assembly instructions. To turn motor off,
press the selected speed button again or the On/Off button.
4. When done chopping, press the On/Off button and wait for
blade to stop. Then remove cover by turning it counterclockwise.
Never turn cover back and forth to start and stop the processor.
Never try to remove cover and work bowl together; this can
damage the work bowl.
5 It is important not to let the metal blade fall out of the work bowl
as you empty it. Before tilting bowl, use a spatula to remove
food from around the blade. Carefully remove the blade by the
plastic hub.
6. Hold top of blade in place with finger or spatula while pouring out
processed food. At this point you may either lift the work bowl off