Sterling Scale 825 User Manual
Page 12
_____________________________________________________________________________________________________________
Revision 4.4 Copyright ©2004Sterling Scale Co., Inc. March 2005
Web Site:
www.sterlingscale.com
E-mail: [email protected]
SMP
Selects the default sample scale. Two scale operation is an option on the 810/825.
To modify the sample scale settings:
1.
Select “SMP T” and press the PRINT key.
2.
Press the TARE key to select sample on scale 1, scale 2 or both.
3.
Press the PRINT key to save the selection.
NOTE: Single scale operation will not allow for the changing of this parameter.
CNT
Selects the default count scale. Two scale operation is an option on the 810/825.
To modify the count scale settings:
1.
Select “CNT T” and press the PRINT key.
2.
Press the TARE key to select count on scale 1, scale 2 or both.
3.
Press the PRINT key to save the selection.
NOTE: Single scale operation will not allow for the changing of this parameter.
TIME
This parameter allows the time and date to be modified. Time and date is an option.
To modify the time and date:
1.
Select “TIME T” and press the PRINT key.
2.
The current month is displayed.
3.
Enter the new month using one of the following methods:
a.
Using the ZERO, TARE and UNITS keys.
b.
Using the 0-9 and BS keys.
c.
Press the PRINT key to move to the next entry.
4.
The current date is displayed.
5.
Enter the new date using one of the following methods:
a.
Using the ZERO, TARE and UNITS keys.
b.
Using the 0-9 and BS keys.
c.
Press the PRINT key to move to the next entry.
6.
The current year is displayed.
7.
Enter the new year using one of the following methods:
a.
Using the ZERO, TARE and UNITS keys.
b.
Using the 0-9 and BS keys.
c.
Press the PRINT key to move to the next entry.
8.
“CENT F” is displayed. To have the century printed out select “CENT T”.
a.
Using the TARE key select the correct century.
b.
Press the PRINT key to move to the next entry.
9.
The current hour is displayed.
10.
Enter the new hour using one of the following methods:
a.
Using the ZERO, TARE and UNITS keys.
b.
Using the 0-9 and BS keys.
c.
Press the PRINT key to move to the next entry.
PARAMETER SETUP AND CALIBRATION
Page 10