Sterling Scale 825 User Manual
Page 7
_____________________________________________________________________________________________________________
Revision 4.4 Copyright ©2004Sterling Scale Co., Inc. March 2005
Web Site:
www.sterlingscale.com
E-mail: [email protected]
Parameter Setup Operation
Parameter setup may be accessed using the following method:
1.
From the Weigh Mode press and hold the GROSS/NET key. The DW810/825
displays “GRSNET” to signify that the GROSS/NET key has been pressed. After
approximately 3 seconds the indicator displays “PARAMS” at which time the key may
be released. If the indicator responds with the message “LOCKED”, then Jumper “J8”
is the wrong position. Jumper “J8” must be removed before access to Parameter Setup
is allowed.
(See Jumper Settings)
2.
Once access is allowed to Parameter Setup, the NTEP F parameter along with its
current value is displayed.
NOTE: Always set to “F” unless factory set.
3. Press
the
PRINT key to select the desired parameter.
4. Press
the
TARE key to select the value for the currently selected parameter.
5. Press
the
PRINT key to save the currently selected parameter.
6.
Repeat steps 3 thru 5 until parameters are set as desired.
7.
Press the GROSS/NET key or RESET key to exit Parameter Setup.
Parameter List
PARAMETER SETUP AND CALIBRATION
Page 5