Jumper settings, Jumper list – Sterling Scale 825 User Manual
Page 6
_____________________________________________________________________________________________________________
Revision 4.4 Copyright ©2004Sterling Scale Co., Inc. March 2005
Web Site:
www.sterlingscale.com
E-mail: [email protected]
Jumper Settings
In order for the 810/825 to operate as desired hardware, Jumpers must be set properly.
Most of the jumper setting’s are set correctly at the factory and never need to be altered, but
occasionally there is a need to alter a jumper setting, therefore they are shown below
Jumper List
Number Name
Setting Description
J8
NTEP/CTS
NTEP
Enable
NTEP
operation
CTS
Enable
CTS
flow
control
J9
RAM
8K
Use
8K
RAM
32K
Use
32K
RAM
J10
EPROM
256
Use
27C256
EPROM
512 Use
27C512
EPROM
J12
Back
light
On
Back
light
on
Off
Back light off
J13*
Load Cell Sense (+)
On
Not using load cell sense wires (+)
Off
Using
load
cell
sense
wires
(+)
J14*
Load Cell Sense (-)
On
Not using load cell sense wires (-)
Off
Using
load
cell
sense
wires
(-)
*NOTE: Jumpers “J13” and “J14” must both be either connected or disconnected to avoid
improper weighing and/or possible damage to the indicator.
INSTALLATION
Page 4