Panels, 1 front panel – Studio Electronics Boomstar User Manual
Page 13
Studio Electronics Boomstar Manual
9
Panels
5
PANELS
5.1 Front Panel
5.1.1 Adjustment Holes
These unmarked holes on the front panel are motherboard access points for calibration potentiometers, set by
none other than Greg St. Regis, or a trained factory tech, and tweaking them without a knowledge and familiarity
of their function could result in your Boomstar sounding and playing quite poorly; that being said, some interesting
drive and VCA offset settings can be tailored to one’s own preferences—proceed at own risk.
, or exact equivalent is recommended.
IMPORTANT WARNING: ONLY AN ANALOGIA INC./STUDIO ELECTRONICS RECOMMENDED
SCREWDRIVER OR EXACT EQUIVALENT CAN BE USED TO CHANGE THE BOOMSTAR’S FRONT PANEL
ADJUSTMENT HOLE SETTINGS TO INSURE UNIT IS NOT DAMAGED. BE CERTAIN TO STRICTLY
FOLLOW THIS REQUIREMENT. AN IMPROPER TOOL, AND OR IMPROPER USE OF SAID TOOL MAY
RESULT IN SERIOUS DAMAGE TO SYNTHESIZER AND OR SERIOUS INJURY TO OPERATOR. THE
OPERATOR OF THIS SYNTHESIZER ASSUMES ALL RESPONSIBILITY AND LIABILITY. ANALOGIA
INC./STUDIO ELECTRONICS OWNERS, OFFICERS,AND EMPLOYEES ASSUME NO RESPONSIBILITY
OR LIABILITY FOR PERSONAL AND PROPERTY DAMAGE INCURRED DUE TO ACCIDENT, CARELESS
HANDLING, ABUSE OR MISUSE, IMPROPER CONTACT OR GROUNDING, OR IMPROPER TOOLS OR
THEIR IMPLEMENTATION. OWNERSHIP AND OR USE OF BOOMSTAR SYNTHESIZER CONSTITUTES AN
AGREEMENT WITH THESE TERMS.
Holes from left to right:
5.1.1.1
#1 CV input tracking adjust.
5.1.1.2
#2 Oscillator 1 high tune adjust.
5.1.1.3
#3 Oscillator 1 octave adjust.
5.1.1.4
#4 Oscillator 1 initial tune adjust.
5.1.1.5
#5 Oscillator 1 scale adjust.
5.1.1.6
#6 Oscillator 2 scale adjust.