Studio Electronics Boomstar - Manual (Page 9)

Studio Electronics Boomstar Manual 5 Setup Essentials
2.3 Smart and Safe Connections
Always power-off all audio gear before making any connections. Failing to do so may damage your speakers, or
other audio equipment and possibly your Boomstar Synth.
After completing all connections, set all levels to 0. Power on the various devices with audio amplifier or monitoring
system last, then raise the volumes to an appropriate listening level.
a) Plug Boomstar +/-15 VDC power supply male 5 pin din plug into female 5 pin din connector mounted on the right
side of back panel, near bottom of synth (marked Pin 1/: Com...).
b) Plug female 3 prong IEC cable plug into +/-15 VDC power supply male 3 prong IEC socket.
c) Plug male 3 prong IEC cable plug into AC outlet.
Note: A switchable power strip is recommended and highly useful for power recycling.
BOOMSTAR POWER ADAPTER REMOVAL PROCEDURE:
a) Unplug female 3 prong IEC cable plug from +/-15 VDC power supply.
b) Unplug female 3 prong IEC cable plug from AC outlet.
c) Unplug Boomstar male +/-15 VDC power supply plug from female connector on the right side of back panel, near
bottom of synth (marked Pin 1/: Com...).
IMPORTANT WARNING: DO NOT POWER ON OR OFF THE BOOMSTAR BY ANY OTHER
METHOD THAN THAT SPECIFIED ABOVE TO PREVENT DAMAGE TO UNIT. BE CERTAIN
TO STRICTLY FOLLOW THE AFOREMENTIONED CONNECTION PROCEDURE CAREFULLY
AND ACCURATELY. THE IMPROPER CONNECTION AND DISCONNECTION OF THIS POWER
SUPPLY MAY RESULT IN DAMAGE TO SYNTHESIZER AND SUPPLY. THE OPERATOR
OF THIS SYNTHESIZER ASSUMES ALL RESPONSIBILITY AND LIABILITY. ANALOGIA
INC./STUDIO ELECTRONICS—OWNERS, OFFICERS, AND EMPLOYEES, ASSUME NO
RESPONSIBILITY OR LIABILITY FOR PERSONAL AND PROPERTY DAMAGE INCURRED DUE
TO ACCIDENT, CARELESS HANDLING, ABUSE OR MISUSE, IMPROPER CONNECTION AND OR
INSTALLATION, OR IMPROPER ELECTRICAL CONTACT OR GROUNDING. OWNERSHIP AND
OR USE OF BOOMSTAR SYNTHESIZER CONSTITUTES AN AGREEMENT WITH THESE TERMS.