TechniSat DigitRadio 50 - Manual (Page 8)

8
>If you want to listen through the speakers again, unplug the headphones from the
headphone jack of the device.
Switching the device on/off
> You turn the device turn on or off by pressing volume / standby ( 3).
Initial use
When you use the device for the first time, as well as after calling the factory setting
and switching on again, the channel search for DAB radio stations starts automatically.
During scanning, the display shows the progress of information and the number of
radio stations found.
After completion of the station search, the first station is displayed in alphanumeric
order and played back automatically.
Note :
If no stations are found, no signal could be received. In this case change the location of
the device and / or the position of the wire antenna and run the scan channels again.
Volume adjustment
>Rotate to adjust volume on / standby ( 3) the desired volume.
- clockwise ->louder
- counterclockwise -> lower
Set display brightness
>Select by pressing the snooze / dimmer button (7), the desired display brightness
(off, dim or bright) from. During the standby you adjust the brightness with the unit
shut and the radio is operating at power on.
Select DAB-/FM-Operation
>Turn on the dial Mode / Menu (2) to switch between DAB mode and FM mode. Dur-
ing the change from one mode to the newly selected mode will appear below the big
time.