Toa N-8000 Series Ver.1.41 - Manual (Page 196)

5-52
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 2
Step 3. Click "Function Settings 2" tab to display the following setting screen.
Available item differs depending on the type of IP stations.
Step 4. Set individual items.
(1) Incoming call mode
Call receiving mode can be selected either "Automatic connection" or "Continuous call". Call with a call
tone or without a call tone can be set on both modes.
The IP door station is fixed to "Automatic connection" mode.
(2) Level
Microphone sensitivity: Station hands-free microphone sensitivity can be adjusted in three increments
from 1 (minimum) to 3 (maximum). The default sensitivity is Level 2.
Note
The sensitivity for the handset microphone is fixed (not adjustable).
Speaker output: Station speaker output level can be adjusted in five increments from 1 (minimum)
to 5 (maximum). The default sensitivity is Level 3.
Call volume: Station call volume can be adjusted in five increments from 1 (minimum) to 5
(maximum). The default sensitivity is Level 3.
(3) Group call (max. 15) (IP master station only)
Set a group of up to fifteen stations that will be called simultaneously when the IP station being set now is
called. With this setting, even when a called station is busy, any registered station in the group can
respond.
(4) Calls transferred to (IP master station only)
Set the station number to which each transfer is to be directed.
Call forwarding receiving station can be set only when the call forwarding function is enabled. (Refer to
p. 5-49 .)
Note
The station to be called via Multi interface unit cannot be programmed as a transfer destination station.