Twin Eagles TEGH48 - Manual (Page 15)

ELECTRICAL INSTRUCTIONS – G AS I NFRARED H EATER
The receiver is powered by four 1.5V AA batteries located in a battery pack inside the heater
component compartment. These batteries should be adequate for the heater operation for a whole
season.
5-2) To install the AC Adaptor
An AC/DC volt adapter can be used in which case the batteries will become a back-up voltage supply.
The adapter must NEVER be located inside the heater control compartment. If adapter is used, provide
a 120-volt outlet near the end of the heater but not directly above the heater.
a. Run the power lead connectors of the AC
adapter through the small hole next to the
gas inlet.
c. The AA batteries go in the in the battery
pack located inside the component
compartment. When the adapter is used
the batteries will work as a back-up.
13
Power Male
Terminals
For Gas
Inlet
Adapter
Leads
NOTE: Always
have the battery
pack switch on the
“Latching
Solenoid” side.
b. Connect terminals of the adapter to the
“POWER” male terminals of the electronic
controller, there is no polarity. Then plug
in your adapter to the 120V power outlet.
5-1) To install the battery on the wireless remote control:
a. Slide out the battery cover at the back of the remote control.
b. Place the battery into the battery slot with the polarities
pointing towards the appropriate polarity. Then push the battery
in. Push the ON button to verify that the red indicator turns on.
Then place the face plate back on with the Twin Eagles logo at
the bottom near the LO button .