Twin Eagles TEGH48 - Manual (Page 8)

LEAK TEST PROCEDURE
CAUTION BEFORE TESTING
 Finding and/or fixing a gas leak is NOT a “DO-IT-YOURSELF” procedure.
 NEVER USE THE PATIO HEATER WITHOUT FIRST LEAK TESTING THE GAS
CONNECTIONS.
 WARNING: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS. USE OF AN OPEN
FLAME COULD RESULT IN A FIRE, EXPLOSION AND BODILY HARM.
 DO NOT SMOKE WHILE PERFORMING THE LEAK TEST!
 To prevent fire or explosion hazard, DO NOT use or permit sources of ignition in the area while
performing a leak test. Perform leak test outdoors only.
 Check to ensure that the flexible hose does not have any cuts and wear that may affect the safety
before each use. Only the factory supplied hose and regulator must be used. Use only replacement
regulator and hose assemblies specified by Twin Eagles.
 If you are using a propane tank, check to ensure that there are no holes, dents, rusted weak spots,
cracks, or other damage on the propane tank. If any damage is detected, the tank should be
replaced immediately .
LEAK TEST
1) Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and
half water.
2) Confirm that the heater is in the OFF position.
3) Turn the main gas valve supply ON.
4) Apply leak testing solution by spraying on the pipe joints, valve fittings and hose.
5) A gas leak is detected if;
a) there is a faint gas smell and/or…
b) growing bubbles appear on any of the connection points and/or hose. DO NOT attempt to
ignite the heater and IMMEDIATELY turn off the gas supply valve.
6) When there is a gas leak, call a qualified service technician. DO NOT use the heater until the leak
is corrected.
6