VACUUBRAND PC 600 LAN - Manual (Page 23)

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. Manual-no.: 999084 / 05/10/2009
page 23 of 46
☞ Use keys ▲ or ▼ in the program menu to select an item.
☞ Confirm selection with key ”Enter”.
☞ Adjust parameters with keys ▲ or ▼.
☞ Confirm with key ”Enter” or return to original setting pressing ”Esc”.
Displays in basic mode ”VACUU•LAN”
Process running, pressure above lower
pressure value
Process
Time delay, pressure below lower pressure value: xxx min
Key ”ENTER” pressed: xx.x Hz (only with VARIO pumps during process)
After process, check of pressure: Monitor
Key ”ENTER” pressed after process: xxx/min (increase of pressure)
Notes on operating a local vacuum network VACUU•LAN ®
p
Set 1
p
Set 2
p
Set 3
system pressure (pressure in vacuum tubing)
network pumping unit
Ports with non-return
valves
Assembling the components of a VACUU•LAN ® - network:
A VACUU•LAN ® -vacuum network consists of three main components: vacuum pump or vacuum
pumping unit, vacuum tubing and ports.
The ports, i.e. the VACUU•LAN
® -modules, are composed of connecting parts, basic parts and
operating parts. They can be combined or adapted in accordance to the requirements in the laboratory.
A non-return valve is integrated in each VACUU•LAN
® -module.
The messages are always displayed in the second line, the first line always displays the pressure
value.
Status messages displayed during operation of a program
In remote mode: P is displayed in the second line.
Program menu in mode VACUULAN and VCL 8cyl
VACUULAN
t Off
VACUULAN
p Set
VACUULAN
p On
VACUULAN
tProcess
t Off
15 min
p Set
25mbar
p On
150mbar
tProcess
99 h
1013mbar
Start
Esc
↵ ↵↵ ↵↵ ↵ ↵↵ ↵↵ ↵ ↵↵ ↵↵ ↵ ↵↵ ↵↵