Compaq 110 - Manual (Page 94)

5–26 Maintenance and Service Guide
Removal and Replacement Procedures
4. Turn the computer top side up with the front facing you.
5. Disconnect the diskette drive cable from the low insertion
force (LIF) connector on the system board 1 (Figure 5-16).
6. Disconnect the TouchPad cable from the LIF connector on
the system board 2.
7. Remove the two M2.5 × 4.5 screws securing the top cover to
the base enclosure 3.
8. Lift the top cover straight up to remove it from the base
enclosure 4.
Figure 5–16: Removing the Top Cover
Reverse the above procedure to install the top cover.
238850-003.book Page 26 Friday, December 21, 2001 2:53 PM