4 . 5 — s – Wilson Audio WATCH Center Series 3 User Manual
Page 24
3. Install the spikes as shown in Figure 9 above.
Note: the material used for the bottom of the Center channel Wilson’s proprietary high
density composite X-material. While very hard, X-material is easily cross threaded when
installing the spikes. Be careful that the spike thread is engaging properly into the bot-
tom.
10. Carefully lift the Center channel into the desired location and set it
down.
Note: 4 small brass disks have been provided for use as spike pads. Place these under
the spikes to protect the finish of your floors.
11. Turn to Section 4.8 for final assembly instructions.
Section 4.5—Setup #2 Center Channel on Stand
1. Set the stand in the desired listening location.
2. Attach the spikes to the bottom of the stand by screwing the spike and nut
combination until the nut is flush with the bottom (See Figure 11).
Note: Do not tighten the nut at this time. Wait until the fine-tuning has been completed
for the entire system and the speaker has been leveled.
Note: Four small brass disks have been provided for use as spike pads. Place these under
the spikes to protect the finish of your floors.
3. Using provided 3/16 Allen wrench, remove the 4 setscrews from the bottom
of the Center channel. Keep these as they are the setscrews needed to as-
semble your spikes and may be required during final setup.
4. Bolt the Center channel to the stand using the four 3/8 – 16 threaded socket
head cap screws and washer provided (see Figure 11).
F
IGURE
9 - I
NSTALLING
THE
S
PIKES
F
IGURE
11 – I
NSTALLING
THE
C
ENTER
C
HANNEL
S
TAND
S
PIKES
T
HREADED
S
PIKES
S
PACERS
(
USE
ONLY
IF
INDICATED
IN
TABLE
)
S
PIKE
AND
N
UT
O
NLY
D
IODE
, S
PIKE
,
AND
N
UT
F
IGURE
10 – I
NSTALLING
THE
C
ENTER
C
HANNEL
S
PIKES
S
E C T I O N
4 . 5 — S
E T U P
# 2 C
E N T E R
C
H A N N E L
O N
S
T A N D
W A T C H C
E N T E R
C
H A N N E L
S
E R I E S
3 O
W N E R
’
S
M
A N U A L
46
47
W i l s o n A u d i o S p e c i a l t i e s
W i l s o n A u d i o S p e c i a l t i e s