Wilson Audio WATCH Center Series 3 - Manual (Page 25)

Note: Do not overtighten the bolts; a snug fit is all that is required to secure the Center
Channel to the stand.
5. Turn to Section 4.8 for final assembly instructions.
Section 4.6—Set Up #3 Center on Custom Stand or Shelf
The WATCH Center Series 3 is a non-shielded speaker and therefore, should NOT be
placed near a CRT television. However, the Center channel can be placed near plasma or
LCD televisions.
We recommend that you have a custom shelf built that allows the Center channel to
be bolted securely above the screen and rotated down toward the listening position. Sec-
tion 11 contains the requirements for this bracket. The speaker should be rotated so that
the midrange drivers are firing just below the listening position. Once you have made and
mounted the custom bracket, setup the Center channel as follows:
1. Lay the Center channel onto its side.
2. Using the provided 3/16 Allen wrench, back out the 4 setscrews from the
bottom of the Center channel to the desired length.
Note: Be sure that the Allen key end of the setscrew is facing out.
3. Carefully lift the Center channel and set the threaded setscrews into the 4
mounting holes located on the top of the mounted custom shelf.
F
IGURE
12 – B
OLTING THE
C
ENTER
C
HANNEL TO THE
S
TAND
A
NCHOR
B
OLT
S
ET
S
CREW
4
PLACES
A
LLEN
K
EY
E
ND OF
S
ET
S
CREW
F
IGURE
13 – L
OCATING THE
S
ET
S
CREWS
S
E C T I O N
4 . 6 — S
E T
U
P
# 3 C
E N T E R O N
C
U S T O M
S
T A N D O R
S
H E L F
W A T C H C
E N T E R
C
H A N N E L
S
E R I E S
3 O
W N E R
’
S
M
A N U A L
48 49
W i l s o n A u d i o S p e c i a l t i e s W i l s o n A u d i o S p e c i a l t i e s