Wilson Audio WATCH Center Series 3 - Manual (Page 43)

Note: It is best to place an old towel under the driver so that you will not dam-
age the enclosure when unsoldering the driver.
3. Using a 900 degree F soldering iron, heat up the solder joints and remove
the driver.
4. Melt a small 1/8” diameter bead of solder onto the tip of each wire. Heat the
wire up until you see the solder wick into the copper.
5. Place the replacement driver onto the cloth and solder on the wires to the
driver. The white wire connects to the positive side, and the black wire con-
nects to the negative. The positive side is generally indicated by a red dot.
Make sure to heat up the solder joint completely and hold firmly in place
until the solder sets.
6. Replace the driver foam gasket.
7. Place the driver into the machined recess.
8. Replace the machine screws, tightening them to 30 inch/pounds of torque.
Note: Be careful not to over tighten the screws.
W A T C H C
E N T E R
C
H A N N E L
S
E R I E S
3 O
W N E R
’
S
M
A N U A L
84
W i l s o n A u d i o S p e c i a l t i e s
S e c t i o n 9 — S p e c i f i c a t i o n s