Wilson Audio Cub Series 2 - Manual (Page 55)

A-1
T
R O U B L E
S
H O O T I N G
G
U I D E
S
ECTION
6.0 T
ROUBLESHOOTING
S
ETUP DIFFICULTIES
Problem Reason
One channel is not operating... Check inter-connects from source.
Check the connections on the speaker cables.
Both at amplifier and speaker ends. Watch espe-
cially for connector touching each other.
Imaging is off center... Check your connections. When a tweeter or mid-
range driver is not working, or is out of phase, the
imaging will be off. Double check your connec-
tions for red-to-red and black-to-black.
Play music at a low level, and listen to each driver
in each channel. You may have a driver that is
not operating correctly. If you find a driver that is
silent please go to the “Driver Out section” of this
troubleshooting guide.
A chronic lack of bass energy...Check the input cable connections on your woofer
enclosure. If one channel is out of phase (con-
nections reversed), bass will be cancelled.
Note: Turn off your amplifier, and unplug it from
the wall.
If you have found a driver that would not play,
move to the rear of this particular loudspeaker.
Driver not playing after
connections have been
verified.