Wilson Audio Cub Series 2 - Manual (Page 61)

R
E P A I R
P
R O C E D U R E S
R
EPLACING A BLOWN RESISTOR
The cub loudspeaker had protective resistors that will blow if the speaker is over-
driven, or if a power surge moved through the system. This is done so that the driver is not
damaged. Replace a resistor on the cub as follows:
1. Determine which driver is not playing music.
2. Remove the appropriate crossover can from the back of the cub enclosure by
removing each of the 10-32 button head machine screws from the crossover
see figure below.
Note: Support the crossover as you remove the screws so that is does not fall and damage the
internal wiring.
10-32
M
AHCINE
S
CREW
H
IGH
F
REQUENCY
C
ROSSOVER
L
OW
F
REQUENCY
C
ROSSOVER
B-1