Wilson Audio Cub Series 2 - Manual (Page 62)

C
U B
O
W N E R
ʼ
S
M
A N U A L
B-2
3. Heat up the leads of the resistor with a 45 watt soldering pencil and remove
the faulty resistor (see figure below).
4. Wrap the leads of the new resistor around the ends of the posts and re-solder
the leads.
Note: The tweeter resistor value is 4.2 ohms
The low frequency resistor value is 1 ohm
5. Re-attach the crossover can to the enclosure, making sure not to over tighten
the screws.
Resistor
Soldered
Posts