Crimestopper Security Products CS-2012DPII-TW1 - Manual (Page 19)

19
TROUBLESHOOTING cont.
UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START:
The system is in Valet mode. Check the systems LED light and if it is on solid Red LED (with doors closed)
then the system is in VALET mode. To exit VALET, turn the Ignition on, press and hold valet/programming
button for about 5 seconds until LED goes out. Unit is now out of valet mode and should perform a remote
start.
SYSTEM DOES NOT RESPOND TO THE REMOTE CONTROL:
1. Check for proper power/ground wiring connections of the alarm.
2. Check Antenna Module connection. The antenna included with this system must be plugged in to
send/receive signals as the Antenna Module gets voltage from the main control module. See antenna
diagram section in Installation Manual. NOTE the color of the antenna harness connectors must match
with the colors of the sockets i.e. Blue plug into the Blue socket and Black plug into the Black socket.
3. The Remote may need a new battery or need to be reprogrammed to operate the system. See
“Transmitter programming” for more information.