Crimestopper Security Products CS-2012DPII-TW1 - Manual (Page 8)

8
OPERATING INSTRUCTIONS - ALARM
Remote AUX. Output 2 (Optional)
This system contains a second auxiliary output to activate other accessories or devices. To activate Output 2, press
and hold Button 2 & 3. This is a momentary output that will stay active as long as the remote button is held down.
Remote output #2 requires programming before operation. Check with your installer or follow programming option
instructions in the installation manual.
Remote AUX. Output 3 and 4 (Optional)
This system contains a 3
rd & 4 th auxiliary output to activate other acc or devices. To activate Output 3 press button 1&4
and release for Output 4 press and release button 3&4. These outputs can be program for Momentary, Latch or Timed.
Check with your installer or follow programming option instructions in the installation manual.
Dome Light Illumination (Optional)
This feature will turn on the vehicle’s dome light upon disarming for 30 seconds or until the key is inserted and turned
on. This will provide illuminated entry to your vehicle in dimly lit areas for safety and security.
Emergency Override (Disarm)
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to disarm the
system manually. Open the door with the key [alarm will sound], turn the ignition on, and press the override/program
button for about 5 seconds. The Alarm will disarm and allow you to use the vehicle until you can repair/replace the
remote. Note you have to put the system into valet mode to prevent passive arming.
Valet Mode (Enter manually or using the remote)
To disable Alarm and Remote Engine Starting for vehicle servicing or otherwise, turn the ignition on and press the
override/program button [about 5-7 seconds] until you hear (3) siren chirps and the LED turns on solid. Repeat the
process to exit VALET mode. To enter / exit valet via the remote, press and hold both buttons #1 (Lock) and Button #2
(unlock) together for about 3 seconds until 3 chirps are heard. Repeat this step to exit via the remote transmitter.
Lock/Unlock and AUX features will still operate when in VALET mode however remote start and alarm functions are
inhibited.
Valet Park Mode (Using the remote transmitter only)
Note: Valet Park mode is only accessible when using the remote transmitter. Valet park mode allows you to turn over
the vehicle to a valet allowing access to drive/lock/unlock your vehicle, but alarm will trigger if the trunk is opened. To
activate Valet Park, press and hold both buttons #1 (Lock) and Button #2 (unlock) together for about 3 seconds. 3
chirps will be heard first when unit goes into regular Valet. Release, press and hold both buttons again you will hear 2
more chirps. LED will flash slowly when in Valet Park. Repeat step to exit Valet Park mode.