Ram Trucks 2015 ProMaster Commercial - Uconnect 5.0 Manual - Manual (Page 90)

2D/3D Settings
Press this button to set the default view of the map. To switch between 2D and 3D views
while driving, press the left side of the status bar in Driving View.
It is sometimes easier to view the map from above, such as when navigating a complex road
network.
The 2D view shows a two dimensional view of the map as though viewed from above.
The 3D view shows a three dimensional view of the map as though you are driving through
the landscape.
The following buttons are available:
• In 2D view: rotate map in direction of travel — Press this button so the map is
rotated automatically with the direction you are travelling always at the top.
• Switch to 3D view when following a route — Press this button to show the map
automatically in 3D view when you are following a route.
7
NAVIGATION 89