Squaring table assembly, Installing table assembly – Sears 113.226424 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Siide table assembly onto rod.
WARNING: TO AVOID TRAPPING THE WORK
OR FINGERS BETWEEN THE TABLE AND SAND
ING SURFACE, THE TABLE EDGE SHOULD BE A
MAXIMUM OF 1/16-INCH FROM SANDING SUR
FACE. TABLE ASSEMBLY SHOULD BE COM
PLETELY ENGAGED ON ROD.
5.
Install and tighten set screw with Allen (Hex)
wrench.
6.
There is an auxiliary mounting hole in the
base. This is for mounting the table when the
belt is used in a vertical position by moving
the
complete
rod/worktable
assembly
and
toggle bolt. Note and follow the above
, WARNING for table clearance.
SQUARING TABLE ASSEMBLY
WARNING:
TO
AVOID
INJURY
FROM
AC
CIDENTAL START, MAKE SURE TOOL IS UN
PLUGGED BEFORE ALIGNING.
1. Using a combination square, check the angle
of the worktable with the disc.
NOTE: The combination square must be “true”
— See start of assembly section on Pg. 6 for
checking method.
2. If the table is not 90° with the disc . .. loosen
table lock knob screw and tilt table.
3. Adjust worktable square to the disc and re
tighten table lock knob.
^ Adjust pointer to 0° mark on trunnion with
^ Phillips
screwdriver
if
necessary.
11