Installing pulley cover, Installing sanding disc plate – Sears 113.226424 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PULLEY COVER
INSTALLING PULLEY COVER
1.
Locate the pulley cover and one screw
1/4-20x1-3/4"
2.
Place pulley cover into position shown and
fasten with one screw. Do not overtighten.
INSTALLING SANDING DISC PLATE
1.
Locate sanding disc plate, sanding disc, one
setscrew - 2 0 x i n c h , and a 1/8 inch hex
wrench.
2.
Just start screw into threaded hole in sand
ing plate.
3.
Align flat on shaft with setscrew in sanding
plate. Slide sanding plate onto shaft until
plate surface and shaft are nearly flush. Do
not allow shaft to extend out past surface of
sanding plate or damage nnay occur to your
sanding disc during operation.
SANDING DISC PLATE
DRIVE
SHAFT
SANDING
PLATE
GUARD NOT
SHOWN FOR
CLARITY
.FLAT
(ON SHAFT)
SANDING
aATE
4,
To tighten setscrew, reach through hole in
top of pulley cover with hex wrench. Tighten
setscrew very firmly.
SECTION Of
PULLEY COVER
BEi^OVtO FOR
U^E CLARi i V