Sears 113.226424 - Manual (Page 12)

assembly
NOTE: This unit comes with the sanding belt
installed.
REPLACING THE SANDING BELT­
TENSIONING AND TRACKING
WARNING: TO AVOID INJURY FROM ACCI­
DENTAL START, TURN SWITCH “OFF” AND
REMOVE PLUG FROM POWER SOURCE OUT­
LET
BEFORE REMOVING OR INSTALLING
SANDING BELT. USE ONLY SEARS RECOM-
MENbED
SANDING BELTS. SEE SEARS
CATALOG.^ ^
On the smooth side of the sanding belt you will
find a “directional arrow.” The sanding belt rriust
run in the direction of this arrow so that thè
splice does not come apart.
1. Slide tension kriob to the right to release the
belt tension. ^ ^
2. Place the sanding belt over the pulleys with
the directional arrow pointing as shown.
Make sure the belt is centered on both
pulleys.
^ ; V
DIRECTIONAL ARROW
3.
4.
Slide tension knob to the left to apply belt
tension.
Plug in the power cord. Turn switch “ON"
and immediately “OFF”, noting if the belt
tends to slide off the idler pulley or drive
pulley. If it did not tend to slide off, it is
TRACKING properly.
5. If the sanding belt moves toward the disc,
turn the tracking knob counterclockwise 1/4
turn. :
6. if the sanding belt moves away from the disc,
turn the tracking knob clockwise 1 /4 turn.
7. Turn switch “ON” and immediately “OFF”
again, noting belt movement. Readjust track­
ing knob if necessary.