Warning: for your own safety, turn, Recommended accessories, Cat. no – Sears 113.226424 User Manual
Page 19: Troubf® shooting
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
troubf® shooting
WARNING:
FOR YOUR OWN SAFETY, TURN
SWITCH “OFF” AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING YOUR SANDER.
TROUBLE
“
PROBABLE CAUSE
REMEDY
Motor will not run.
1. Defective On-Off switch.
Defective switch cord.
Defective switch box.
2. Burned out motor.
1, Replace defective parts before
using belt disc sander again.
2. Consult Sears Service. Any at
tempt to repair this motor may
create a HAZARD unless repair is
done by a qualified service techni
cian. Repair service is available at
your nearest Sears Store.
Machine slows down
when sanding.
№
1. Timing belt too tight.
2. Applying too much pressure to
workpiece.
1. Decrease belt tension, see
Assembly Section.
2. Ease up on pressure.
Sanding Belt runs
off pulleys.
1, Not tracking properly.
1.
Adjust
tracking,
see
Assembly
Section,
“Replacing
the
Sanding
Belt — Tensioning and Tracking”
Wood burns while
sanding.
1. Sanding disc or belt is
glazed with sap.
1. Replace disc or belt.
RECOMMENDED ACCESSORIES
ITEM
CAT. NO.
Miter Gauge....................................................9—24214
Sanding Belts and discs.............................See Catalog
Leg Set.......................................... .....................9-22244
The
above
recommended
accessories
are
current
and were available at
the time this
manual was printed.
19