Bevel sanding, Positioning belt table, Basic operation – Sears 113.226424 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
basic operation
BEVEL SANDING
The worktable can be tilted from 0“ - 45“ for
bevel sanding. Loosen the table lock knob and
tilt the worktable to desired angle as shown.
Retighten table lock knob.
Loosen rod locking toggle bolt. Slide table in so the
table is no more than 1/16" from the sanding surface.
WARNING: TO AVOID TRAPPING THE WORK
OR FINGERS BETWEEN THE TABLE AND SAND
ING SURFACE, THE TABLE SHOULD BE RE
POSITIONED ON THE TABLE SUPPORT ROD TO
RETAIN A MAXIMUM OF 1/16-INCH DISTANCE
BETWEEN SANDING SURFACE AND TABLE.
Retighten rod locking toggle bolt.
POSITIONING BELT TABLE
Two belt table locking bolts lock the belt table in
a vertical or horizontal position.
To adjust vertical position:
a. Remove the backstop.
b. Loosen the two belt table locking bolts using
a 1/2-inch wrench.
c. Position belt table vertically as shown and
tighten the two bolts.
15