Sears 113.226424 - Manual (Page 18)

basic operation
WARNiNG: APPLYING THE WORKPIECE TO THE
RIGHT SIDE COULD CAUSSE IT TO FLY UP
(KICKBACK) WHICH COULD BE HAZARDOUS.
Always position the workpiece to the left of center on
sanding disc with disc rotating counter-clockwise as
shown.
.....
The table may be tilted for beveled work. s
CENTER
WORKPIECE .
(LEFT OF CENTEi
maintenance
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH“OFF” AND REMOVE PLUG FROM POW'ER
SOURCE OUTLET BEFORE ADJUSTING, MAIN­
TAINING, OR LUBRICATING YOUR BELT AND DISC
SANDER.
If power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Frequently blow out or vacuum out any dust that may
accumulate inside the motor,
A coat of automobile-type wax applied to the worktable
will make it a little easier to feed the work while finishing.
Do not apply wax to the abrasive belt table because
the bbit couW pick up the wax and deposit it on the
pulleys, causing the belt to slip.
WIRING DIAGRAM
LUBRICATION
The BALL BEARiNGS in this machine are packed
with grease at the factory. They require no further
lubrication.
,
18