Onkyo TX-SV535 - Manual (Page 21)

Using the tuner
2 ,3 4, > i
-m
2
MEMORY
MEMORY
3
4
"r-T-l
in X
I ' 7i'° • II
Using preset stations
Since ten AM or FM stations can be stored in each group (A, B or C),
a total of 30 stations can be stored in the memory.
Programming radio station
1. Select the frequency that you want to store in the memory.
(See page 20 Tuning the radio)
2. Press the MEMORY button.
The MEMORY indicator will light for 8 seconds.
.3. While the MEMORY indicator lights, press the GROUP hut-
ton to choose the desired group.
The group shown on the display changes in the following order
each time the button is pressed: A ^ B ^ C ^A.
4. Select the desired memory number using the number buttons.
Press button 0/10 when choosing memory number 10.
NOTE (European model only):
If the FM station received is an RDS station with a PS (Program Ser­
vice Name), the frequency display will change to the PS display. If
there is no PS. the frequency display will not change.
(Refer to page 22 ~ 24 for the RDS function)
Selecting preset stations
Main unit
. Press the GROUP button to select the desired group.
' =. Input the memory number you wish to receive by using the
number buttons.
> -. Press the SCAN (or PRESET SCAN) button.
Each station stored in the group chosen in step I will be received for 5
seconds (for each station).
When the station that you want is (ound, press the SCAN (or PRESET
SCAN) button again and scanning will stop.
Remote control
Q] Press the GROUP button and choose the group.
Press the PRESET (A orV ) button.
After the last number of GROUP C is reached, scanning will restart at
GROUP A.
MEMORY FM MUTE/MODE
o o
L CLEARS
Cancelling preset stations
1. Select the station that you want to cancel as explained in the
previous section.
2. Press the EM MUTE/MODE button while holding down the
MEMORY button.
will be shown on the display.
21