Onkyo TX-SV535 - Manual (Page 29)

Recording a source
TV antenna VCR VCR (for recording] Monitor TV
Rear panel of TX-SV535
»
1
-
1 ^ 1
4
Playback and recording of TV picture and FM/
CABLE TV sound
Recording of a TV broadcast and FM broadcast (simulcast) is possible
when two VCR are used.
1. Receive the TV broadcast using the VCR tuner.
2. Press the VIDEO-2 or -3 input selector to set the picture to
VIDEO-2 or -3.
3. Press the FM Input Selector and tune in the FM simulcast
using a preset button or the tuning selectors.
The picture will be sent to the monitor TV and the FM stereo
sound to the speakers connected to this unit.
4. To record the TV picture with FM sound, receive the TV broad­
cast using one VCR (connected to VIDFO-2 (or 3)) and begin
recording on the other VCR (connected to VIDFO-3 (or 2)).
The program can be monitored during recording.
Mixing video and audio for VCR recording
1. Press the Input Selector button to select the VCR (VIDEO-1, 2
or 3) that will be used to play the video.
2. Press the REC/PAUSE button on the VCR (VIDEO-2 or 3)
that will be doing the recording.
3. Press the REC OUT button.
4. Press the Input Selector button (CD, PHONO, FM, AM,
TAPE-1 or TAPE-2) that will provide the audio source.
5. Start operation of the equipment.
The picture will be left as is. Only the audio will be changed. The
picture will be recorded from the video source, and the sound from
the audio source.
29