Troy-Bilt 14066 - Manual (Page 3)

GENERAL INFORMATION
Introduction
The purpose of this manual is to assist you in
maintaining and operating your BOLENS loader.
Read it carefully; it furnishes information and in­
structions that will help you achieve years of
dependable performance. Some information may
be general in nature due to unknown and varying
conditions. However, through experience and
these instructions, you should be able to
develop operating procedures suitable to your
particular situation.
“Right” and “Left” as used throughout this
manual are determined by facing the direction
the machine will travel when in use.
The photos, illustrations and data used in this
manual are current at the time of printing, but
due to possible in-line production changes, your
machine may vary slightly in detail. Extra equip­
ment that may be shown on the machine is op­
tional at extra cost. The Manufacturer reserves
the right to redesign and change the machine as
may be necessary without notification.
Important:
Illustrations used in this Manual may not show
all safety equipment that is recommended to en­
sure safe operation of tractor/loader. Refer to
Safety Section of this Manual and the Tractor
Operator’s Manual for information concerning
safety equipment. Consult your Dealer for further
information.
Warranty Registration
The Warranty Registration form must be'filled
out and signed to validate your warranty. See
your Dealer for Details.
Sériai Number and Location
The serial number is important information about
the machine, and it may be necessary to know it
before obtaining the correct replacement part.
The serial number is located on the right side of
loader subframe as shown. The serial number
should be recorded on the Warranty Registration
form. Figure 1.
Replacement Parts
Genuine BOLENS replacement parts only should
be used to repair this machine. BOLENS replace­
ment parts are available from the local BOLENS
dealer. To obtain prompt, efficient service,
always remember to give the dealer the following
information:
1. Correct part description or part number.
2. Model number of your machine.
3. Serial number of your machine.
10-1