Garmin Edge 800 - Manual (Page 52)

48 Edge 800 Owner’s Manual
Appendix
replacing the Heart rate
Monitor Battery
1. Use a small Phillips screwdriver to
remove the four screws on the back
of the module.
2. Remove the cover and battery.
3. Wait 30 seconds.
4. Insert the new battery with the
positive side facing up.
NOTE: Do not damage or lose the
O-ring gasket.
5. Replace the back cover and the four
screws.
After you replace the heart rate monitor
battery, you must pair it with the device
again ( page 12 ).
replacing the gSC 10 Battery
1. Locate the circular battery cover
➊
on the side of the GSC 10.
➊
➋
2. Use a coin to twist the cover
counter-clockwise until it is loose
enough to remove (arrow points to
unlocked).
3. Remove the cover and the battery
➋
.
4. Wait 30 seconds.
5. Insert the new battery with the
positive side facing up.