Cres Cor CCBC-4-35 - Manual (Page 14)

[ Section 2-Installation ] [ Page 12 ]
3. Make sure cabinet is sitting level with all four (4) casters (or legs) in contact with the
floor.
4.
Also make sure the door stays open when opened past 90 degrees.
5.
Inspect magnetic door gasket to be sure it is making contact on all four (4) sides. Also
make sure it is not cut, torn, twisted or otherwise deformed.
6.
Check installation of shelves or pan slides .
7.
Check electrical power source for correct voltage, phase and ampacity. Refer to cabinet
data plate for requirements.
8.
Remove electrical control box cover and check all wiring connections for a secure hold.
On rare occasions, rough shipping and handling conditions can result in loosening of
connections resulting in electrical problems.
9.
Make sure all miniature circuit breakers are turned on.
10.
Check all fan blades. They should turn freely without touching anything as they spin.
11.
Check electrical power supply cord and plug for any damage and be sure it is not routed
in a way that would permit anyone to trip over it.