Cres Cor CCBC-4-35 - Manual (Page 21)

[ Section 5- Troubleshooting ]
[ Page 19 ]
SERVICE & TROUBLESHOOTING
Setting or Resetting Time and Date
SET UP PROCEDURE
SWITCH FUNCTION IN SPECIAL SWITCH MODE
I/O ON/OFF SWITCH
1 When held in, displays the code for current parameter
2 Step back to previous parameter, and while held in displays the parameter
code. When released, displays the value of the parameter.
3 Advance to the next parameter. (same as above)
Increase the value of the current parameter.
X Decrease the value of the current parameter
To set the parameters complete the following steps:
1. This can only be entered from the panel OFF mode.
2. Press and HOLD IN any key EXCEPT the ON/OFF key for three seconds.
3. While Holding key, press and release the ON/OFF key.
You will now be in the programming mode.
CODE PARAMETER SET AT:
bss Blast Soft Stat 33
bhs Blast Hard Stat 12
bfs Blast Freeze Stat -16
sss Store Soft Stat 33
shs Store Hard Stat 33
sfs Store Freeze Stat -8
bsd Blast Soft Differential 35
bhd Blast Hard Differential 35
bfd Blast Freeze Differtial 35
ssd Store Soft Differential 35
sfd Store Freeze Differential 35
bd1 Blast Duration 1 (normally 30 min.) 30
bd2 Blast Duration 2 (normally 60 min.) 60
bd3 Blast Duration 3 (normally 90 min.) 90
bd4 Blast Duration 4 (normally 240 min) 240
cab Cabinet Number 1
ala Alarm Duration 900 (15 min)
ddc Defrost Duration for Cabinet Hex. Switch
dic Defrost Interval for Cabinet Hex. Switch
ddp N/A defrost Duration for PoD minutes, Set Manually
dip N/A defrost Interval Hours, Set Manually
det Defrost Target Temperature 39
yr Calander Year Setting Set Accordingly
nth Calander Month Setting Set Accordingly
day Calander Day Setting Set Accordingly
hr Calander Hour Setting Set Accordingly
ute Calander Minute Setting Set Accordingly