Cables to Go TE100-S55 - Manual (Page 20)

20
S OFTWARE S ETUP
The default settings of TE100-S55 (shown in Appendix A, page
45) should be sufficient in the majority of installations. If a
different setting is required for your specific environment, please
refer to Chapter 3, page 21 for “Out-of-Band Management” or
Chapter 4, page 35 for “SNMP Management”.
For simple management, you can perform the Out-of-Band
Management and access the TE100-S55 through its RS-232 port.
For elaborate SNMP management, you can run the XPressView
program from any network station.
C
HECKING
S
TATUS
LED
S
When the power is first turned on, TE100-S55 performs a Power-
On Self Test (POST). Please observe the status LEDs for
verification of proper installation (for more detail, refer to
Chapter 5, page 41). These status LEDs also provide information
about the system unit and its connected Ethernet or Fast Ethernet
LAN segments, during normal operation.
Figure Chapter 2 -6, TE100-S55 status LEDs