Cables to Go TE100-S55 - Manual (Page 37)

37
Starting XPressView
After you install the XPressView program, you are ready to begin
SNMP management of your TE100-S55.
• From Windows start screen, click the XPressView icon. The
Welcome screen will appear.
S
TART FROM SCRATCH
If this is your first time to run the XPressView program, you will
need to create an environment that represents the TE100-S55.
• Click the AUTO DISCOVERY icon.
• Enter the range of IP addresses to
search and XPressView will auto-detect all of the TE100-S55
switches in your network.
**As an option, you can click the DEVICE icon and
manually type each IP address of your TE100-S55.
• For future use, save this environment by going to the
NETWORK menu and clicking the SAVE command.
NOTE: Each switch must have a unique IP address in order to
communicate with the network manager. The factory default IP
address of each TE100-S55 is 168.8.xxx.xxx. The last two bytes
of the IP address are identical to the last two bytes of the MAC
address, which is displayed on the back of each TE100-S55. The
MAC address can also be referenced through out-of-band
management (see chapter 3, page 24).