Aussie LP 7462 - Manual (Page 34)

TROUBLESHOOTING
Problem Possible Cause Solution
Flames blow out High or gusting winds Turn front of grill to face wind or increase flame height.
Gas in LP cylinder is tow Check LP gas cylinder. Refill if necessary.
Excess flow valve tripped See “Low flame” problem above
Flare up Grease build up Clean grill
Excessive fat in meat Trim fat from meat before grilling
Persistent grease fire Grease trapped around burn­
er system
Turn control knobs "off and turn handle of LP cylinder clock­
wise until it stops. Open hood carefully (Bonza™ series only)
and let fire burn out. After the grill cools, remove and clean all
parts.
Unable to fill LP tank Some dealers have older fill
nozzles with worn threads. The worn nozzles do not have enough "bite” to engage the
valve. Try another licensed LP dealer or purchase a new tank
with an OPD (Overfilling Prevention Device.)
Humming or whistling
from the regulator
Outside temperature, humidi­
ty, barometric pressure, and
the gas level within the tank
may cause the rubber
diaphragm inside the regula­
tor to vibrate, making a hum­
ming or whistling sound.
Although this sound may be alarming, this is NOT dangerous as
long as it is not accompanied by the smell of gas. Simply adjust
the burner settings and usually the sound will subside. If the
humming sound persists, a change in atmosperic conditions will
eventually stop the vibration. Should you smell gas, do not use
the grill and call Customer Service at 1-800-251-7558
if your problem is not resolved from the information provided above, please call Customer Service at
1-800-251-7558,
34