ADT Security Services Commercial Fire & Burglary Alarm System FOCUS 200 PLUS - Manual (Page 57)

System Operation (cont’d)
4. Press the “Group description” button to turn off that specific group.
5. Repeat steps 2 through 4 to turn off additional groups.
6. Press Continue to display Action Menu 1.
Turning Off One or More Burglary Groups Using a Key or Card Reader
1. Insert or swipe the access key or card. The green lamp will illuminate on
the key/card reader. If you are using a key, turn the cylinder to unlock
the door. If you are using a strike, pull the door open.
Note: If the green lamp does not light and the red lamp “winks” out
momentarily, it indicates the system is rejecting the access attempt.
The system can reject access for the following reasons:
a. User does not have “irregular open” privilege, and the present time is
outside the schedule or is a holiday.
b. “Lockout” option is selected, and the present time is outside the
schedule or is a holiday.
c. User does not have “open” privilege, and group(s) are on.
d. User does not have “access” privilege to this group or area.
Resetting Current Alarms
Resetting alarms is used after one or more alarms have been activated and
you have determined that the situation has returned to normal.
1. Using the operating panel’s numeric keypad, enter a valid ID code to
display Action Menu 1 (if no Burglary groups are on) or the Turn Off
Menu (if Burglary groups are on) and to deactivate all annunciating
devices.
2. If Burglary groups are on, complete the steps under the heading Turning
Off One or More Burglary Groups. When all Burglary groups are off,
press Continue to display Action Menu 1.
3. Press Reset to display the reset choices.
57