ALESIS HR-16:B - Manual (Page 26)

function is used to echo any MIDI information that is received at
the MIDI input to the MIDI output. The display looks like this:
MIDI ECHO
05 ECHO MIDI IN
TO MIDI OUT: ON
The +/- arrow buttons are used to turn this function on or off. The default is ON.
The HR-16 will not echo system exclusive data.
MIDI PROGRAM CHANGE
The MIDI PROGRAM CHANGE function is used to allow MIDI program change
commands to select pattern numbers. MIDI programs 00 through 99 will select
patterns 00-99, and MIDI programs 100-127 will select patterns 00 through
27. The display looks like this:
06 MIDI PROGRAM
PATT SELECT: OFF
The +/- arrovv buttons are used to turn this function on or off. The default is OFF.
When ON, incoming MIDI program change commands will select patterns.
Program changes will be ignored while a pattern or song is playing.
CLOCK SOURCE
The clock source function is used to select what clock will drive the HR-16. The
display will show one of the three following choices:
07 CLOCK SOURCE:
MIDI & INTERNAL
07 CLOCK SOURCE:
INTERNAL ONLY
07 CLOCK SOURCE:
lAPESYNCIN
By using the keypad or +/- arrow buttons, one of the three clocking sources can
be selected. The default setting is MIDI & INTERNAL (1), with the other choices
being INTERNAL ONLY (2), and TAPE SYNC IN (3).
Alesls HR-16 Instructions ..................................................................................................................................... 20