Start / stop footswitch, Remaining memory, Clearing memory – ALESIS HR-16:B User Manual
Page 68: Start/stop footswitch 8, Remaining memory 8, Clearing memory 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2) Press and hold the CLOCK button. The display will read:
CLOCK SOURCE
MIDI & INTERNAL
3) Use the keypad or + and - buttons to select TAPE SYNC IN. The display will read:
CLOCK SOURCE
TAPE SYNC IN
4) Put the tape machine into PLAY. The MMT-8 will automatically start as soon as it
receives the sync tone, causing any other sequencers connected to it to play. Be careful
to return to the beginning of the sync tone since the MMT-8 will automatically begin
playing any time that it receives the sync tone.
START / STOP FOOTSWITCH
The START/STOP footswitch jack is provided for a momentary normally open footswitch
that connects the jack’s tip to its sieeve (ground). While in stop, the footswitch will function
like the play button and start a part or song from the beginning. While in play, the
footswitch acts like the stop button, and stops playing.
REMAINING MEMORY
Holding RECORD and pressing LENGTH causes the following display:
REMAINING MEMORY
too PERCENT
This shows the amount of memory that has not been used. Note that some
operations may not be possible even though it seems that there is still a small
amount of memory available. This is due to the fact that the MMT-8 requires
enough memory to duplicate a part before it can be recorded on, or length changed,
or offset, etc. If a large part is attempted to be altered when there is not enough
memory to complete the operation, the display will indicate that there is not
enough memory available to complete the operation.
CLEARING MEMORY
To clear all of the MMT-8's memory and reinitialize all of its variables, turn power off, press
and hold ERASE, PAGE UP, and PAGE DOWN, and turn on the power while holding
these buttons down for 3 seconds.
Alesis MMT-8 Instructions
Page 28