AEG TURBO 1480 - Manual (Page 12)

Connection
Electrical Details of the mains voltage, type of current and protection
connection required are given on the appliance rating plate which can be
found on the frame, after opening the porthole door.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety
measure not be observed.
If the plug that is fitted to your appliance is not suitable for your
socket outlet, it must be cut off and the appropriate plug fitted.
, Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the hazard
of shocks in case it should be plugged into a 13amp socket in
another part of your home.
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires in the mains lead
of your appliance may not correspond with the markings identify­
ing the terminals in your plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the terminal in the
plug which is marked with the letter «E» or the earth symbol © ,
or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is
marked with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is
marked with the letter «L» or coloured red.
The plug moulded onto the lead incorporates a fuse. For replace­
ment, use a 13amp BS1362 fuse. Only ASTA or BSI approved
fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The cover/
carrier is indicated by the coloured insert at the base of the plug.
12